![]() ![]() LED 2 – Damaged injector circuit, ignition primary circuit, or fuel pump circuit, “INJECTOR/IGNITION FAULT.” For LIGHT ON, investigate possible fault codes: Code 18 – system voltage (55 V) above range.Code 17 – system voltage (55 V) below range.LED 1 – Low charging output, “CHARGING FAULT.”įor LIGHT ON, investigate possible fault codes: LED 4 – Lanyard/Stop circuit not grounded, “LANYARD/STOP OKAY.”įor NO LIGHT, repair grounded stop circuit.įor FLASHING LIGHT ON, investigate possible fault code 29 (engine shutdown, EMM overheat), code 31 (engine shutdown, engine overheat) or code 33 (engine shutdown, excessive no oil condition). LED 3 – Sensor circuits (5 V), “SENSORS OKAY.” For NO LIGHT, investigate possible fault codes: 12, 13, 24, 16, 41, 42, 44, 45, 46, 47, 48, 49, 67, 68, 69.įor FLASHING LIGHT ON, investigate code 57 (High RPM with low TPS setting) LED 2 – Crankshaft position sensor output, EMM powered (ON), “CRANK POSITION OKAY.” For NO LIGHT, investigate possible fault code 16. LED 1 – Stator signal 30 V or higher, “CHARGING OKAY.” For NO LIGHT, investigate S.A.C. ![]() “Starting mode” occurs from EMM power ON until outboard is running for 2 seconds. The EMM has LED indicators located next to the electrical connectors that provide information related to various electrical circuits. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |